|
Using
the T5 VictoryLap Timer
Definitions:
Short
Press; Pressing of button for not longer than three seconds.
Long
press; Pressing of button for three seconds with green light
activation.
Tips:
Lap and
Start review mode,
1.
Long
press, in any main menu screen, will display last lap or
start session reviewing times
2.
To
speed up the reviewing, use short button presses to quickly
scroll through times
3.
Lap
or start review times will not be erased if timer turns off
automatically or is done manually
Before going
out on the tack,
1.
Make
sure timer is strapped to front fender securely and in
position to view lights properly
2.
Set
“Review Settings” to predetermined settings – short
press during that menu will verify settings
3.
Short
press of button in mode “ Practice Laps or Practice
Starts” will place timer in proper mode for practice
session
Review
Settings Descriptions:
Time
Diff –
Time difference between laps or starts that are being
calculated to determine green or
red light. The time difference must be greater than the
setting choice to get a
green light. 1/100 of second – 1/10 of second – 1 second
(We like the 1 second setting for laps and the 1/10 or 1/100 second setting for starts)
Note:
After the completion of the first lap there is no
light indication as there were
no previous laps for time difference calculations.
Time
Limit – Length
of time for laps session.
Programmed in 5-minute intervals to
60 minutes. At the end of the time period the red
light will flash. Times will
continue to be recorded normally if practice session
is continued, so if you feel
strong keep going!
Distance Laps
– Number
of laps in session. Programming
options are 5,7,9,11,13,15,and then in increments of 5’s up to
65. One lap
before the total number programmed is completed the red light will flash,
white flag lap. The red and green light will flash upon completion of the
last lap, indicating the number programmed has been
completed. Timing is stopped so further laps in that session
will not be recorded.
Battery
Replacement:
1.
Remove
the four cover screws
2.
Carefully
remove PC board and foam
3.
Unplug
the old 9volt battery and plug in the new one
4.
Route
the wires for the switch so as not to lay on top of battery
5.
Place
foam on top of battery ( between battery and PC board )
6.
Align
PC board on top of foam and center in box
7.
Carefully
align cover so PC board is centered in box and replace
screws
8.
Do not over tighten screws – just snug
|